Dolmar TM-98.14 H2D Manuel D'utilisation page 137

MAINTENANCE
– Put the machine onto a flat surface and
check the tyre pressures;
– put 26 mm blocks (1) under the front
edge of the deck and 32 mm blocks (2)
under the rear edge, and then put the
lifting lever into position «1»;
– fully loosen the adjuster (3), the nuts (4 –
6 – 8) and the locknuts (5 – 7 – 9) of the
three trace rods until the deck is resting
on the blocks;
– screw the two upper right nuts (6 – 8)
and the lower left nut (4) until the deck
starts rising; tighten the three locknuts (5
– 7 – 9) and turn the adjuster (3) until the
control cable is taut.
Any difference in height from the ground
between the right and left side of the deck
can be compensated by turning the two
nuts (4 – 8) and locknuts (5 – 9) of just the
back rods.
Move the control lever to 2 or 3 different
positions, making sure that the deck rises
evenly and that the difference in height
from the ground remains the same
between the front and rear edge.
If the front part rises too early or too late, you can regulate the movement by
turning the nuts (10) on the connecting rod (11).
Screwing the nuts on the rod makes the rear part rise earlier, while unscrewing
them does the opposite.
Always remember to fully tighten all the nuts and locknuts when the adjustment
has been made.
If you are unable to get the cutting deck adjusted properly, consult a Licensed
Service Centre.
1 - h = 26 mm
9
5
8
4
6
7
EN 39
2 - h = 32 mm
3
11
10