Dolmar TM-98.14 H2D Manuel D'utilisation page 114

EN 16
your toe-cap, noting that
increasing the pressure on
the pedal progressively
increases the speed of the
machine.
– Reverse is engaged by
pressing the pedal with the
heel, in the «R» direction.
– The pedal automatically
goes into neutral «N» when
released.
WARNING!
!
must only be engaged
when the machine is
stopped.
NOTE
pedal is used, whether for-
wards or for reverse, when
the parking brake (4.4) is
engaged, the engine stops.
4.33 L
EVER TO RELEASE THE HYDROSTATIC TRANSMISSION
The lever has two positions, as shown by the symbols:
«A» = Transmission engaged: for all usage conditions, when moving
«B» = Transmission released: considerably reduces the effort
IMPORTANT
must be carried out only when the engine has stopped with the pedal (4.32)
at position "N".
Reverse
If the drive
and during cutting;
required for moving the machine by hand, with the engine
turned off.
To avoid damaging the transmission unit, this operation
CONTROLS AND INSTRUMENTS
4.32
N
R
4.31
F
4.33
B
A