Dolmar TM-98.14 H2D Manuel D'utilisation page 109

UNPACKING AND ASSEMBLY
IMPORTANT
ting in, never start the engine until the battery is fully charged!
WARNING!
!
safe handling and disposal.
3.5 FITTING THE STONE-GUARD
Inside the stone-guard (1), fit the spring (2) by inserting the terminal (2a) into the
hole and turning it so that both the spring (2) and the terminal (2a) are securely
positoned in their seatings.
Position the stone-guard (1) in line with
the cutting deck brackets (3). Using a
screwdriver, turn the second terminal (2b)
of the spring (2) to bring it outside the
stone-guard.
Fit the pin (4) in the holes on the brackets
(3) and on the stone-guard, so that it
passes thrugh the coils of the spring (2)
and the drilled end comes out of the inner
most bracket.
Fit the cotter pin (5) in the hole (4a) of the
pin (4) and turn the pin until the two ends
(5a) of the split pin can be bend (using
pliers), so that it cannot slip out and let
the pin fall out (4).
WARNING!
!
spring works correctly and keep the
stone-guard securely lowered. Make
sure that the pin is fitted properly to
prevent it from falling out accidently.
To prevent the safety device in the electronics card from cut-
Follow the battery manufacturer's instructions regarding
Check that the
1 2a
2
1
3
4
4
4a 5
EN 11
2
2b
2
2b
3
1
2
3
5a