Description Of Function; Functions And Features - resideo Braukmann KaltecSoft Instructions D'installation

It is recommended to set a residual water hardness of
at least 8°dH resp.15°fH to avoid corrosion damages.
To set a residual water hardness turn the blending
knob on the left side of the valve anti-clockwise until
the water meets your requirements.
8.
Testing for the water hardness in your
area:
Water hardness can vary from one location to another.
To determine the fresh water (unsoftened supply water) use
the hardness test kit supplied.
9. Switching on for the first time:
• Check that the inlet hoses and outlet hoses or
couplings are properly connected i.e. inlet-to-inlet,
outlet-to-outlet
First the main tap of the mutiblock should be fully closed
position by turning clockwise.
• Check that the mains stop valve open
• Check that the Brine Cabinet (see 3.5 Technical
overview of device) contains salt
• Check that the water softener is connected to the
drain and the overflow pipe is connected
The drain and overflow must not be linked to each
other.
• Now open the main tap of the mutiblock by turning
counter clockwise
• Turn ON the power to the softener, you will hear the
valve move quietly into the start position. When the
positioning process has been completed (which can
take up to 5 minutes) you will hear the movement stop,
the valve has now reached its start position in
preparation for the programming procedure
• Check for leaks, take corrective action to stop leaks if
required
– Your water softener is now on line and you may
start the valve programming procedure set out in
the 2 Quick Operation Section of this manual
MU1H-1420 GE23 R0420
GB
4

Description of Function

4.1 Functions and features

Capacity requirement-dependent of the unit
controller:
The unit operates according to the principle of intelligent
regeneration.
The average capacity level of each model is preset and
updates automatically to the actual consumption within 7
days.
The presetting is appropriate for the most common
applications.
It is not necessary to adjust the unit for individual
requirements.
Intelligent quantity-dependent regeneration:
When the unit is started, the available supply of softened
water is programmed (depending on the hardness of the
water).
At a user-defined time (e.g. at night), the unit checks whether
the remaining supply of softened water is sufficient for the
following day.
If this is not the case, the softening column is regenerated by
only the exact percentage necessary to fully replenish the
supply of softened water to 100 %.
Note: With intelligent regeneration, the remaining supply of
softened water is not wasted.
This intelligent regeneration method is possible because of
the precision flowmeter, which is able to adjust the amount of
brine required for partial regeneration.
The consumption of regenerative and water is reduced to the
required minimum.
In the event of a power failure, the data and the time are
retained (for a limited amount of time).
Options:
Disinfection
The unit is optionally equipped with a device that disinfects
the ion exchange resin during the regeneration (KS30I-xx).
Salt type
Use only salt tablets acc. EN 973.
9