Sony SU-WL450 Informations D'installation page 12

4
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
6.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Standard mounting (2-a)
Belt 
Slim mounting (2-b)
5
Connect the necessary cable(s)
to the TV or LCD Monitor.
Make sure to connect the cables before
installing the TV or LCD Monitor on the
wall. You will be unable to connect the
cables when the TV or LCD Monitor is
installed.
Note
 Subcontract the cable routing in the wall to a licensed
contractor.
 Bundle the connecting cables to prevent stepping on
them before wall mounting.
Pulley 
Screw
(+PSW 6 x 20) 
Screw
(+PSW 6 x 50) 
Spacer (60 mm) 
Pulley 
Screw
(+PSW 6 x 20) 
Spacer (20 mm) 
Belt 
− 12 (GB) −
6
Detach the Table-Top Stand
from the TV or LCD Monitor.
 Remove one side of the Table-Top Stand
at a time. Firmly hold the Table-Top
Stand securely with both hands while
the other people lift up the TV or LCD
Monitor.
 Repeat the previous step and remove
the other side of the Table-Top Stand.
Note
 Three or more people are required to detach the
Table-Top Stand.
 Be careful not to use excessive force while detaching
the Table-Top Stand from the TV or LCD Monitor as it
may cause the TV or LCD Monitor set to fall resulting
in personal injury or physical damage to the TV or
LCD Monitor.
 Take care when handling the Table-Top Stand to
prevent damage to the TV or LCD Monitor.
 Be careful when lifting the TV or LCD Monitor as the
Table-Top Stand is detached, the Table-Top Stand
may topple over and cause personal injury.
 Take care when removing the Table-Top Stand from
the TV or LCD Monitor to prevent it from falling over
and damaging the surface that the TV or LCD Monitor
is sitting on.