Csa Standard - Stihl MS 150 C Notice D'emploi

Masquer les pouces Voir aussi pour MS 150 C:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

CSA Standard

CSA-Standard Z62.3-11 sets certain
performance and design criteria related
to chain saw kickback. To comply with
CSA Z62.3-11:
a. saws of class A and C shall not
exceed 45° computed kickback
angle (CKA). Operation of the chain
brake may be taken into
consideration for compliance with
this requirement (CKA
wb
chain has stopped before the bar
has reached the maximum
deflection, the requirement also is
complied with if this lower computed
kickback chain stopping angle
(CKA
) does not exceed the limit of
cs
45°
b. saws of class B shall not exceed 25°
CKA under the conditions as
mentioned above and have a guide
bar with a nose radius no greater
than 25 mm. An automatic chain
brake activated upon kickback is
mandatory, so is a low kickback saw
chain
The computed kickback angles are
measured by applying a computer
program to test results from a kickback
test machine.
WARNING
In order to comply with the computed
kickback angle requirements of
CSA Z62.3-11, use only the following
cutting attachments:
50
All manuals and user guides at all-guides.com
a bar and chain combination as
N
listed in this instruction manual
other replacement saw chains for
N
use on specific powerheads or
a low-kickback saw chain
N
STIHL offers a variety of bars and
chains. STIHL reduced-kickback bars
and low-kickback chains are designed to
reduce the risk of kickback injury. Other
chains are designed to obtain higher
productivity or sharpening ease but may
result in a higher kickback tendency.
). If the
Please ask your STIHL dealer to
properly match your powerhead with the
appropriate bar/chain combinations to
reduce the risk of kickback injury. Low-
kickback saw chains are recommended
for all powerheads. See the charts of the
STIHL Bar and Chain Information for
details.
WARNING
Use of other, non listed bar/chain
combinations may increase kickback
forces and increase the risk of kickback
injury. New bar/chain combinations may
be developed after publication of this
literature, which will, in combination with
certain powerheads, comply with
CSA Z62.3-11. Check with your STIHL
dealer for such new combination
updates.
Definition of the Chain Saw Classes
according to CSA-Standard Z 62.1-11
Class 1A
A fuel powered professional chain saw,
intended for use by trained workers,
where the operator is expected to use
the chain saw for extended periods of
time on a daily basis
Class 1B
A fuel powered professional chain saw
for tree service, limited to a dry weight of
4.3 kg (9.5 lb), intended for use by
trained workers, where the operator is
expected to use the chain saw for
extended periods of time on a daily basis
Class 1C
A fuel powered consumer chain saw,
intended for general use by
homeowners, cottagers, campers, etc.,
and for general applications such as
clearing, pruning and cutting firewood
Class 2A
An electrically powered professional
chain saw, intended for use by trained
workers, where the operator is expected
to use the chain saw for extended
periods of time on a daily basis
Class 2B
A battery powered professional chain
saw, intended for use in tree service
work, limited to a weight of 5 kg (11 lb)
with battery
MS 150 C

Publicité

Table des Matières
loading

Table des Matières