Stihl MS 150 C Notice D'emploi page 19

Immediately before felling the tree, give
out a second warning cry of "timber!".
Cut through the holding wood at an
N
angle from above with arms fully
extended
MS 150 C
All manuals and user guides at all-guides.com
B) Thick trunks
1.
2.
5.
4.
Implement this backcut when the trunk
diameter is greater than the cutting
length of the machine.
Engage the bumper spike behind
N
the holding wood and use this as the
rotation point – reposition the chain
saw as little as possible
Tip of the guide bar must penetrate
N
the wood before the hinge (1) –
guide the chain saw absolutely
horizontally and swivel as widely as
possible
Do not cut into the holding wood and
–
hinge
Make the backcut up to the
N
hinge (2)
Do not cut into the hinge
–
Make the backcut up to the holding
N
wood (3)
Do not cut into the holding wood
–
The backcut must be continued on the
opposite side of the trunk.
Ensure that the second cut is at the
same level as the first cut.
Engage the bumper spike behind
N
the hinge and use this as the
3.
rotation point – reposition the
machine as little as possible
Tip of the guide bar must penetrate
N
the wood before the holding wood
(4) – guide machine absolutely
horizontally and swivel as widely as
possible
Make the backcut up to the
N
6.
hinge (5)
Do not cut into the hinge
–
Make the backcut up to the holding
N
wood (6)
Do not cut into the holding wood
–
Immediately before felling the tree, give
out a second warning cry of "timber!".
English
17