Attaching The Lens Cap; Adjusting The Grip Belt; Inserting A Cassette - Panasonic Palmcorder MultiCam PV-VM202 Mode D'emploi

1
3
1
2
1
1
OPEN/EJECT
2
R E C
SAVE

Attaching the Lens Cap

2
To protect the Lens surface, attach the Lens Cap.
1
Pass the loop of the Lens Cap Cord through the Lens Cap
Installation Hole on the Palmcorder.
2
Pass the opposite side of the Lens Cap Cord through the
cord's hoop.
3
Pull the Lens Cap to the direction of the arrow.
4
Attach the Lens Cap.
≥The removed Lens Cap can be hooked onto the Grip Belt
are not recording, be sure to keep the Lens Cap attached to the Lens for
4
protection.)
≥If the supplied Lens Hood for MEGA STILL
attached, the Lens Cap cannot be attached.
1
~~~~~~~~~~~~~~~~~~~~~~~~~

Adjusting the Grip Belt

Adjust the length of the Grip Belt to the size of your hand.
1
Pass your hand through the Grip Belt and adjust its length.
2
Fold back the end of the Grip Belt to securely fasten the
velcro tape closure.
≥The Grip Belt can also be adjusted in SD Camera Style.
~~~~~~~~~~~~~~~~~~~~~~~~~

Inserting a Cassette

When power is supplied to the Palmcorder, the cassette can be taken out
without turning the Palmcorder on.
2
1
Slide the [OPEN/EJECT] Lever
to open the Cassette Compartment.
2
Insert a Cassette.
3
Close the Cassette Compartment and lock the Cassette
Compartment by pressing the [PUSH TO CLOSE] mark.
4
Close the Lower Cassette Compartment Cover.
3
≥For other notes, see page 60.
4
ª Accidental Erasure Prevention
Opening the accidental erasure prevention slider
sliding it in the [SAVE] arrow direction) prevents recording. To enable
recording, close the accidental erasure protection slider (by sliding it in the
[REC] arrow direction.)
1
. (When you
TM
Pictures Recording is
1
to the right and pull down
2
on the cassette (by
13