PV-GS400Eng.book 10 ページ 2004年6月4日 金曜日 午後3時17分
Quick Guide
1
Attach the Battery to the AC Adaptor and
charge it.
≥Before use, fully charge the Battery.
≥Since the Battery will not be charged when
the DC Cable is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥The [CHARGE] Lamp lights up, and charging
starts.
≥When the [CHARGE] Lamp goes off,
charging is completed.
2
Attach the charged Battery to the
Camcorder.
ª Inserting a Cassette
1
Slide the [OPEN/EJECT] Lever 1 toward the
front and pull down to open the Cassette
Compartment Cover.
2
Insert a Cassette.
3
Close the Cassette Holder by pressing the
[PUSH] mark 2.
4
Close the Cassette Compartment Cover.
2
PUSH
10
Before Use
ª Inserting a Card
1
Slide the [OPEN] Lever 1 to open the Card
Slot Cover 2.
2
While holding the Memory Card with its cut
corner on top 3, insert it into the Card Slot.
3
Close the Card Slot Cover 2 securely.
ª Recording on a Tape
1
Set the [OFF/ON] Switch 1 to [ON].
≥The [POWER] Lamp 2 lights up.
2
Set the Mode Dial to Tape Recording Mode.
3
Press the Recording Start/Stop Button.
≥Recording starts.
1
4
Press the Recording Start/Stop Button
again to pause the recording.
2
1
OPEN
3
2
POWER
ON
1