PV-GS400Eng.book 44 ページ 2004年6月4日 金曜日 午後3時17分
Playback Mode
Playing Back a Tape
The recorded scene can be played back
immediately after the recording.
1
Set the [OFF/ON] Switch
≥The [POWER] Lamp
(46)
(46)
POWER
ON
(48)
2
(44)
Set the Mode Dial
Mode.
(44)
3
Press the [6] Button
tape.
STILL
(21)
ENTER
FADE
≥Rewind the tape to the point where you want
to start playback.
≥When the tape reaches the beginning,
rewinding stops automatically.
4
(19)
Press the [1] Button
≥The [!] Indication appears.
STILL
(19)
ENTER
FADE
≥If a cassette recorded with a copyright
protection signal is played back, the picture is
distorted by mosaic-like patterns.
To Stop Playback
(20)
Press the [∫] Button
.
STILL
ENTER
(20)
FADE
44
Playback Mode
ª Adjusting the Sound Volume
To adjust the volume, push the [`VOL/JOG_]
Lever
Push the [`VOL/JOG_] Lever towards [T] to
increase the volume or push the [`VOL/JOG_]
Lever towards [W] to decrease the volume. The
(48)
to [ON].
[VOLUME] Indication goes off after the
lights up.
adjustment is finished.
To adjust the volume with the Remote Controller,
to Tape Playback
press the [T] or [W] Button to display the
[VOLUME] Indication. Press the [T] Button to
increase the volume or press the [W] Button to
decrease the volume. The [VOLUME] Indication
goes off after the adjustment is finished.
(21)
to rewind the
≥The sound volume cannot be adjusted using the
≥For other notes concerning this item, see
Finding a Scene You Want to Play
Back
to start playback.
ª Cue/Review Playback
If the [5] Button
pressed during Playback, it turns to Cue Playback
A or Review Playback B.
≥If the Button is held continuously, it turns to Cue
(51)
to display the [VOLUME] Indication.
VOL/JOG
W
T
(51)
Remote Controller in Playback Zoom Mode.
(
)
-46-
STILL
ENTER
FADE
(21)
(18)
(18)
or [6] Button
A
B
Playback or Review Playback until you release
it.
.
-79-
(21)
is