Knick ProLine P50000 Manuel Utilisateur page 63

Commissioning
Bottom side of the transducer
Use your thumbs to push the DIN rail clip (F) in direction of the arrow until it
snaps in. Place the transducer on the DIN rail and close the DIN rail clip again.
For removing the transducer from the DIN rail, we recommend using a flat-
bladed screw driver to open the DIN rail clip (see F in fig. on page 64).
Mounting example:
Transducer on
TS 35 DIN rail
– input at top, output at bottom
63
F