Setting Of Cooling Compartment Temperature; Gas Operation - Dometic RMDT 8501 Notice D'utilisation

Refrigerator operation
4.6 RMDT 85x1 models
MES-appliances (manual energy selection)
4.6.1 Electrical operation
1
2
To start the refrigerator, press button (1) for 2
seconds.
The refrigerator starts with the last selected
type of energy.
230V operation :
Press button (2) :
12V operation :
Press button (4) :

4.6.2 Gas operation

3
Gas operation :
Press button (3) :
The ignition process is activated automatical-
ly by means of an automatic igniter.
i
The flame extinguishes after reaching the pre-
set cooling compartment temperature and
ignites again if the cooling compartment tem-
perature increases again. If the flame is not lit
after the first ignition attempt, the automatic
igniter repeats the ignition twice (duration 30 s)
at time intervals of 2 minutes. If the flame is
not lit afterwards, a fault is indicated.
3 4
Fig. 9
Fig. 10
4.6.3 Setting of cooling compartment
temperature
Select the desired cooling compartment tem-
perature by pressing button (7) .
The LED display (8) of the selected temperatu-
re setting is illuminated.
The scale starts with MIN position at the left
LED position (small bar = highest temperature)
and climbs up to MAX position at the right
LED position (large bar = lowest temperature).
Note: The temperature levels do not relate to
absolute temperature values.
4.7 RMDT 85x5 models
AES appliances
(manual + automatic energy selection)
4.7.1 Manual operation
1
2
To start the refrigerator, press button (1) for 2
seconds.
The refrigerator starts with the last selected
type of energy.
230V operation :
Press button (2) :
12V operation :
Press button (4) :
Gas operation :
Press button (3) :
16
8
7
3 4
Fig. 11
Fig. 12