Setting Of Cooling Compartment Temperature; Additional Features - Dometic RM 8501 Consignes D'utilisation

Refrigerator operation
4.3.3 Setting of cooling compartment
temperature
7
Select the desired cooling compartment tempe-
rature by pressing button "2".
The LED display "7" of the selected temperatu-
re setting is illuminated.
The scale starts with MIN position at the bottom
LED position (small crystal = highest temperatu-
re) and climbs up to MAX position at the upper
LED position (large crystal = lowest temperatu-
re). Note: The temperature levels do not relate to
absolute temperature values.
The cooling unit's performance is influenced by
ambient temperatures. Please select the medi-
um setting for ambient temperatures between
+15°C and +25°C (refer to Fig. 28, temperature
level 3). The unit operates within its optimum
performance range.
Dometic refrigerators work according to the
absorption principle. For physical reasons, an
absorption system responds slowly to changes
made by the thermostat controller, by loss of
cooling energy through opening the door or
during storing food. The devices meet the coo-
ling performance requirements of the Climatic
Class SN acc. to EN/ISO 7371 in the temperatu-
re range of +10°C to +32°C ambient temperatu-
re.
For temperatures below +10°C, winter
covers should be installed. For ambient tem-
peratures exceeding +32°C for a longer
period of time, it is recommended installing
Dometic additional fan (i tem no. 241 2985 -
00 ).
2
Fig. 18
18
4.3.4 Additional features (MES and AES)
The brightness of the display reduces after a
few seconds if no other buttons are pressed.
If the door is open, the interior lighting is swit-
ched off automatically after 2 minutes.
Failures are indicated by flashing of the failu-
re indicator LED.
Should the door be kept open for too long
(more than 2 minutes), an acoustic signal is
initiated (pulsing whistle tone).
Should the electronic control detect any fai-
lure, an acoustic signal will sound (pulsing
whistle tone). At the same time the display
starts flashing (for trouble-shooting, please
refer to section 4.12 ).