Commissioning; Initial Start-Up; Appliance Handover - Stiebel Eltron MINI-E 2-1 Utilisation Et Installation

COMMISSIONING

DANGER: Electrocution
The appliances are delivered with a power cable to be
connected to a permanent power supply.
Ensure that the proper wire gauge is installed with the
appliance in accordance with the minimum recommended
wire size in section 15.4, "Data table", pg. 20 .
Material losses:
!
When making the connection to a standard wall socket,
ensure that the socket is freely accessible to be easily
disconnected in case of an issue.
Material losses:
!
Take note of the product label. The specifi ed voltage must
match the mains voltage.
 If the appliance is to be hardwired, connect the power cable as 
shown in the wiring diagram (see 15.2, "Wiring diagram", pg.
18).
12 | MINI ™ -E SERIES TANKLESS ELECTRIC WATER HEATERS
11. Commissioning

11.1 Initial start-up

 Before you activate the power supply, fi ll the appliance with 
water fi rst to avoid dry fi ring the heating element.
 Check for leaks. 
 Activate the power supply. 
 Run the tap. 
 Check the function of the appliance. 

11.2 Appliance handover

 Explain the appliance function to users and familiarize them 
with its operation.
 Make users aware of potential dangers, especially the risk of 
scalding.
 Hand over these instructions. 
WWW.STIEBEL-ELTRON-USA.COM