Stiebel Eltron MINI-E 2-1 Utilisation Et Installation page 15

TROUBLESHOOTING
Problem Cause
The required The maximum tempera-
temperature is not ture set inside the appli-
being reached. ance is too low.
The appliance is operating
beyond its output limit.
If you cannot remedy the fault, notify your qualifi ed contractor. To
facilitate and speed up your request, provide the serial number from
the type plate (000000-0000-000000).
Mini-E Nr.: 000000-0000-000000
WWW.STIEBEL-ELTRON-USA.COM
LED indicators
Remedy
Have your qualified install-
er adjust the maximum
temperature.
Reduce the flow rate.
1 Illuminates red in case of a fault
2 Illuminates yellow during heating operation or fl ashes yellow
3 Flashes green if the main control board is receiving power
MINI
1 2 3
when demand is exceeding capacity
™ -E SERIES TANKLESS ELECTRIC WATER HEATERS | 15