Commissioning; Recommissioning; Shutting Down - Stiebel Eltron HDB-E 12 Si Utilisation Et Installation

INSTALLATION

Commissioning

f Adjust the wall clearance and lock the back panel with the f
fixing toggle by turning it clockwise through 90°.
11. Commissioning
WARNING Electrocution
Commissioning may only be carried out by an authorised
contractor in accordance with safety regulations.
11.1 Commissioning
≥ 60 s
f Open and close all connected draw-off valves several times. f
until all air has been vented from the pipework and the
appliance.
f Carry out a tightness check. f
f Activate the safety pressure limiter. The instantaneous water f
heater is supplied with the safety pressure limiter in the trig-
gered state. Activate the safety pressure limiter at flow pres-
sure by pressing the reset button with a screwdriver.
f Fit the appliance cap and secure it with a screw. f
f Switch the mains power ON. f
f Check the function of the appliance. f
f Remove the protective foil from the user interface. f
Appliance handover
f Explain the appliance function to users and familiarise them f
with its operation.
f Make users aware of potential dangers. especially the risk of f
scalding.
f Hand over these instructions. f
www.stiebel-eltron.com

11.2 Recommissioning

Material damage
!
Following an interruption of the water supply. recommis-
sion the appliance by carrying out the following steps. in
order to prevent the destruction of the bare wire heating
system.
f Disconnect the appliance from the power supply by f
removing the fuses/tripping the MCBs.
f Open the tap until the appliance and its upstream f
cold water inlet line are free of air.
f Switch the mains power back ON again. f

12. Shutting down

f Isolate all poles of the appliance from the power supply. f
f Drain the appliance (see chapter "Maintenance"). f
HDB-E Si | 27