X-Rite PPG DigiMatch Guide De L'utilisateur page 2

S P E C T R O P H O T O M È T R E P P G D I G I M A T C H
FCC Supplier Declaration of Conformity Product Identification and Responsible Party
(É.-U.)
X-Rite
www.xrite.com
4300 44th St SE
Grand Rapids, MI 49512 (États-Unis)
MAC-Spectrophotometer
We, X-Rite, declare under our sole responsibility that the product MAC-Spectrophotometer complies
with Part 15 Subpart B of FCC CFR47 Rules.
FCC Compliance Statement FCC 15.19 Labeling Requirements (É.-U.)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Statement (É.-U.)
The device shall be used in such a manner that the potential for human contact normal operation is
minimized. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and your body. This device and its antenna(s) must not be co-located or operating
in conjunction with any other antenna or transmitter.
Canada ISED Compliance Statement - Déclaration de conformité avec la réglementation d'ISDE
Canada
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada's license-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device
2
[2.1077(a)(3)]
[2.1077(a)(1)]