Setup On An Uneven Surface; General View Of Application; Application; Coating Material - WAGNER Finish 270 Mode D'emploi

Finish 270 / 250
1.20

SetuP On An uneVen SuRFAce

The front end must always point downwards in order to avoid
sliding away.
If possible do not use the unit on an inclined surface since the
unit tends to wander through the resulting vibrations.
2

GeneRAl VIeW OF APPlIcAtIOn

2.1

APPlIcAtIOn

Finish 270 / 250 is an electric driven unit for the airless atomi-
zation of different painting materials. Also it is able to feed the
internal feeded paint roller, which is available as accessory.
Finish 270 /250 is made for jobs in the workshop and on the
building site
The unit performance is conceived so that its use is possible
on building sites for small- to middle-area dispersion work.
Finish 250 is designed for varnishing jobs. Small jobs with dis-
persion work are possible.
Both units are able for all common varnishing jobs like
doors, door frames, balustrades, furniture, woodencladding,
fences, radiators (heating) and steel parts.
2.2

cOAtInG MAteRIAl

Diluting lacquers and paints or those containing solvents, two-
component coating materials, dispersion and latex paints.
No other materials should be used for spraying without
WAGNER's approval.
Pay attention to the Airless quality of the coa-
ting materials to be processed.
The unit is able to process coating materials with up to
15,000 mPas. If highly viscous coating materials cannot be ta-
ken in or the performance of the unit is to low, the paint must
be diluted in accordance with the manufacturer's instruc-
tions.
Attention: Make sure, when stirring up with
motor-driven agitators that no air bubbles
are stirred in. Air bubbles disturb when spra-
ying and can, in fact, lead to interruption of
operation.
2.2.1
cOAtInG MAteRIAlS WItH SHARP-edGed
AddItIOnAl MAteRIAlS
These particles have a strong wear and tear effect on valves
and tips, but also on the heating hose and spray gun. This im-
pairs the durability of these wearing parts considerably.
2.2.2

FIlteRInG

Sufficient filtering is required for fault-free operation. To this
purpose the unit is equipped with a suction filter (Item 1) and
an insertion filter in the spray gun (Item 2). Regular inspection
of these filters for damage or soiling is urgently recommen-
ded.
A high-pressure filter (Item 3) -available as accessory- is rising
up the filtering surface and will make the work more comfor-
table.
GB
safety regulatIons
35