Factory Default Settings; Technical Support - Emerson FIPIO numatics G2-2 Serie Guide De Démarrage Rapide

17) Factory Default Settings

Unless otherwise requested, all standard G2-2 Series FIPIO manifolds ship with specific factory default
settings. Below is a list of the factory default settings:
Input Module Power Jumper
Output Module Power Jumper
Valve Side Output Bytes
Discrete I/O Side - I/O Bytes Self-Configuring based on the I/O modules installed.

18) Technical Support

For technical support, contact your local Numatics distributor. If further information is required,
please call Numatics Inc. at (248) 887-4111 and ask for Technical Support.
Issues relating to network set-up, PLC programming, sequencing, software related functions, etc...
should be handled with the appropriate product vendor.
Information on device files, technical manuals, local distributors, and other Numatics, Inc. products
and support issues can be found on the Numatics, Inc's. WEB site at
G2-2 Series FIPIO Quick Start Manual
Description
Node Address
Baud Rate
3835058 TDG22FPQS2-0
Subject to change without notice
www.numatics.com/fieldbus
Default Settings
00
1 Mbit/s
PU
(Input sensor power supplied by
+24VDC Node and Inputs pin on the Aux. power connector)
SP
(Output module power supplied by
+24VDC Valves and Outputs pin on the Aux. power connector)
4 Bytes (32 Allocated Valve Coil Outputs)
1/07
www.numatics.com
Page 17