Emerson FIPIO numatics G2-2 Serie Guide De Démarrage Rapide

Getting Started
This is a brief document designed to quickly get you started setting up your valve manifold with an integrated
Numatics' G2-2 Series FIPIO communication node.
1) Initial Unpacking and Inspection
1) Examine exterior of package for signs of damage. Report any damage to shipping carrier.
2) Remove wrapped manifold assembly from box.
a) Remove manifold assembly from anti-static packaging
b) Retain documentation for installation and configuration
3) Examine manifold assembly for any shipping damage such as:
a) Bent pins or connectors
b) Report any damage to shipping carrier immediately
4) Examine manifold assembly for proper ordered configuration. (Valves, I/O, Protocol, etc.)
2) G2-2 Introduction
Below is an example of a 2012 valve series manifold. This fieldbus manifold series is capable of addressing a
total of 224 I/O. The manifold can be viewed as having two sections to it, the
Side . The Valve Side
maximum of 6 modules totaling 192 Outputs, 96 Inputs, or various combinations. The communication
module has a M23 style 6-pin communication connector. The power module has a 4-pin power connector. Pin-
outs for these, along with I/O connectors, are labeled on the side of the respective modules.
G2-2 Series FIPIO Quick Start Manual
supports a maximum of 32 solenoid coils and the
3835058 TDG22FPQS2-0
Subject to change without notice
www.numatics.com/fieldbus
Valve Side
Discrete I/O Side
Valve Side
(Maximum of 32 Solenoids)
Module/
Chassis Ground
Network Aux. Power
Connection
Status LED's LED's
Valve Side
Sub-D Output
Module
Power
Module
Communications
Module
1/07
Discrete I/O
and the
supports a
Valve
End Plates
Valve
Manual
Override
Solenoid LED
Status Indicator
Page 1