Emerson FIPIO numatics G2-2 Serie Guide De Démarrage Rapide page 15

16) Commissioning a Node to the Network
1) Using the PL-7 software tool, select STD_P from the families list.
2) The user must then choose the appropriate "Base Module", in the STD_P "Family" listing, to match the
physical I/O size configuration of the FIPIO manifold.
3) Always cycle power to node after making any changes (Software or Hardware changes).
A.) FIPIO Reduced Device Profile (FRDP)
Below is a sample
Device Profile (FRDP). This selection can be used when the physical configuration of the manifold is less
than, or equal to, 2 words (4 bytes) of Inputs and 2 words (4 bytes) of Outputs (i.e. valve only manifold).
G2-2 Series FIPIO Quick Start Manual
PL7 Ver. 4.4
software screen showing the appropriate selection of the FIPIO Reduced
3835058 TDG22FPQS2-0
Subject to change without notice
www.numatics.com/fieldbus
1/07
Page 15