Wall Installation; Basic Settings - switel T 36 clip Mode D'emploi

Putting the Telephone into Operation

Wall installation

The telephone can also be installed on a wall. Use two screws to insert in the holding slots.
Drill two holes 67 mm apart vertically under each other, insert the screws and allow them to
project 5 mm from the wall. The tabletop support is not required for wall installation. Position
the slots in the telephone base over the screws, insert and slide the telephone down a little.
In order that the receiver does not fall when placed on−hook, there is a small receiver clip in
the receiver cradle. Use a small screwdriver to turn the clip 180° until a small hook is created
at the top end. You can then place the receiver on−hook.

Basic settings

When the batteries have been inserted, you are requested to program some basic settings. In-
formation on the methods of illustration and notation used in the operating manual is available
on Page 50.
Setting the language
y or z
e.g.: [ENGLISH]
Setting the contrast
y or z e.g.: [4] , C
Setting the time and date
y or z e.g.: [15] , C
y or z e.g.: [31] , C
y or z e.g.: [28] , C
y or z e.g.: [11] , C
48
All manuals and user guides at all-guides.com
Caution: Ensure there are no cables or pipes in the wall where the hole is drilled.
If the handsfree" function is not activated, you can hook the receiver on the telephone
without interrupting the connection. To do this, there is a hook provided above the
receiver cradle.
27
, C
If you want to change these settings at a later date, press and hold the y button
for 4 seconds.
Select the language and confirm
Select the contrast and confirm
Set the hour and confirm
Set the minute and confirm
Set the day's date and confirm
Set the month and confirm