Wall Installation; Basic Settings - switel TC 29 clip Mode D'emploi

Wall installation

The telephone can be mounted on the wall. Use two screws for the necessary fixation. Drill
two holes 84 mm apart and horizontal to each other and insert the screws leaving approx.
5 mm projecting from the wall. The tabletop supports are not required for the wall installation.
Attach the base unit by hooking it in the two screws protruding from the wall and pushing it
down a little.
Attention: Ensure there are no cables or lines under the wall where the holes are
drilled.
In order that the receiver does not fall when placed on−hook, the receiver cradle is equipped
with a small receiver hook. Pull the receiver hook out, turn it 180° and push it back in. You can
then hang the receiver on it.
If the handsfree" function is activated, you can place the receiver on−hook
without disconnecting the call. There is a hook for this above the receiver cradle.
25

Basic settings

Setting the date display format
2x ©
y or z

y or z

2x ©
Setting the time display format
2x ©
y or z

y or z

2x ©
Setting the date and time
2x ©
y or z

y or z


2x ©
All manuals and user guides at all-guides.com
Putting the Telephone into Operation
Press briefly
Select DATE FORMAT" (date display)
Confirm the selection
Select the date display format
(DD−MM / MM−DD)
Confirm the selection
Close the menu
Press briefly
Select HOUR FORMAT" (time display)
Confirm the selection
Select the time display format
(24−hour / 12−hour)
Confirm the selection
Close the menu
Press briefly
Select SET TIME"
Confirm the selection
Set the time and date
Move the cursor to the right
Confirm the selection
Close the menu
63