Operation - Cleanmaxx PC-P008E Mode D'emploi

EN
Attaching / Removing the brush nozzle, tile nozzle, furniture edge brush
and the dusting mop attachment
The brush nozzle, tile nozzle, furniture edge brush and the dusting mop attachment
are attached with the aid of the nozzle adapter for the big nozzles.
• Plug the nozzle adapter into the suction opening (3).
• If desired, fi rst plug the articulated suction tube or the suction hose into the suction
opening and second the nozzle adapter to the articulated suction tube or the suc-
tion hose.
• Plug the nozzle you want onto the nozzle adapter.
• To take them apart, pull the nozzle and the adapter apart.
Attaching / Removing Small Nozzles
• To insert all small nozzles, fi rst the nozzle adapter for the big nozzles must be
plugged into the suction opening (3) and then the nozzle adapter for the small nozz-
les must be plugged onto this.
• All small nozzles are attached to the adapter for the small nozzles.
• To take them apart, pull the nozzle and both nozzle adapters apart.
Removing / Inserting the Dust Container
closed
open

Operation

PLEASE NOTE!
■ Make sure that there are no large, pointy objects on the area to be cleaned.
■ Pay attention to the dust container's MAX mark. If the mark is reached during use, em-
pty the dust container. Empty and clean the dust container after each use. The HEPA
fi lter must also be cleaned regularly to prevent the motor from being overloaded.
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
When the device is switched on, the charge status of the battery (7) is indicated
by the two green battery charge status lamps (2). If both lamps are lit up, the
battery is full. If only the red operating lamp (2) is lit up, the battery needs to be
charged up.
1. Select an accessory as required (see the "Device Overview" chapter – "Accesso-
ries") and attach it to the device (see the "Assembly" chapter).
09122_DE-EN-FR-NL_A5_V2.1.indb 26 09122_DE-EN-FR-NL_A5_V2.1.indb 26
26
• Removing: Twist the dust container (5) a little bit. It is re-
leased from the main unit (10) and can be removed.
• Inserting: Insert the dust container into the main unit. Rotate
it slightly as you do this until it engages in the main unit
correctly. Then twist the dust container in the main unit to
secure it in place. The release button of the dust container
must be located below the suction opening (3) after it has
been attached.
26.03.2019 11:59:05 26.03.2019 11:59:05