Operation
ATTENTION!
■
Keep the nozzles away from animals during use. Do not attempt to vacuum off ani-
mals with the device. The device could attach itself to them and you could be injured.
If the vacuum cleaner attaches itself to the fl oor, turn it off immediately.
■
Only use the device if it has been completely and correctly assembled! The dust bin
and fi lter must be in place. The fi lters may not be damaged!
■
Do not insert anything in the openings / nozzles of the device and make sure that
they are not plugged.
■
Make sure that there are no large, pointy objects on the area to be cleaned.
■
Before you attach / detach any accessories, ensure that the device is not connected
to the mains power.
■
Do not in any case vacuum up the following:
– smouldering ashes, cigarette butts, matches etc.,
– fl ammable or ignitable materials,
– very fi ne dust (e.g. cement dust), ash or toner,
– pointy, hard objects such as larger glass shards,
– liquids and wet dirt.
■
Do not use the device when it is connected to the mains adapter.
1. If you have not already done so, disconnect the mains adapter from the device.
2. Stick the nozzle adapter on the suction opening.
3. If desired, attach one or both extension tubes to the nozzle adapter.
4. Attach the desired nozzle to the extension tubes.
The nozzles can also be attached to the nozzle adapter directly without attaching
the extension tubes between them.
5. Switch the device on. This can be done in one of two ways:
– by gently holding the On / Off switch down. The device will switch off when you let
it go.
– by fi rmly pushing the On / Off switch once and then releasing it. If you would like to
switch the device back off, push the On / Off switch again.
6. Run the device over the area to be cleaned.
7. Turn the device off by releasing the On/Off switch.
8. If you would like to remove the nozzles, simply pull them off the nozzle adapter or
off of the extension tubes.
09623_DE-EN-FR-NL_A5_V7.indb 19
09623_DE-EN-FR-NL_A5_V7.indb 19
19
EN
08.06.2017 08:51:18
08.06.2017 08:51:18