Unpacking &Inspection - Antari W-515D Mode D'emploi

Fog machine output is very hot. Avoid coming within 50 cm of the output
Nozzle during operation.
Operate the fog machine in a well-ventilated area. Never cover the unit's
vents. In order to guarantee adequate ventilation, allow a free air space of
at least 20 cm around the sides and top of the unit. Never aim the output
nozzle at open flames.
If the supply
service agent or similarly qualified personnel in order to avoid a hazard.
The output nozzle becomes very hot during operation (200°C). Keep
flammable materials at least 50 cm away from the nozzle.
Always allow your ANTARI Fog Machine to cool down before attempting to
clean or service it.
Never add flammable liquids of any kind (such as oil, gas, perfume) to the
fog liquid.
Use only high-quality, water-based fog liquid that your dealer recommends.
Other fog liquids may cause clogging or "spitting".
Always make sure there is sufficient liquid in the tank. Operating this unit
without liquid might cause damage to the pump as well as over-heating of
the heater.
If your ANTARI W-515D or W-530D Fog Machine fails to work properly,
discontinue use immediately. Drain all fog liquid from the tank, pack the
unit securely (preferably in the original packing material), and return it to
your ANTARI dealer for service.
Always drain tank before mailing or transporting this unit.
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog
liquid comes in contact with skin or eyes, rinse thoroughly with water.
Note: Pay attention to all warning labels and instructions printed on the exterior
of your ANTARI Fog Machine.
Unpacking &Inspection
Open the shipping carton and verify that all equipment necessary to operate the
system has arrived intact.
The shipping carton should contain the following items:
1. One unit of W-515Dor W-530D Fog Machine
2. Power cord
3. One Set of W-1 transmitter
4. User Manual
If any equipment is missing, contact your ANTARI dealer immediately.
cord is damaged, it must be replaced by manufacturer or its
Danger of Explosion