Bestop 56873 Instructions D'installation page 9

Install Rear"J" Rail Seal
Section 3
Step 1
Align the cut outs to the fender bolts.
Remove the paper backing from the
adheasive on the side with the cut outs
and adhere the film to the vehicle.
Note:
It is very important to align the
cut outs to the fender bolts first.
P9 - 56873 Rev. J 1121
Rear Seal Film Right (Shown)
Part #610.36
Qty.1
Rear Seal Film Left
Part #610.37
Qty.1
Align with this bolt
Installation Instructions - Trektop for Bronco 4 Door
Parts
Step 2
Remove the paper backing from the other
side of the film and adhere the rest of the
film to the vehicle.
Note:
Rear film will overlap the front film.
Repeat these steps on left side of vehicle.
Page 9
© 2021 Bestop, Inc.