Bestop 56873 Instructions D'installation page 29

Section 21 Mount Upper Rear Door Rails
Tools
T30 and T40
Torx Driver
Parts
Screw,M8 X 1.25mm X 28mm
SCREW, M6 X 1.0 X 15mm
Part #534.24
Part #533.61
Qty. 4
Qty. 4
T-30 Torx T-40 Torx
Upper Rear Door Rail Right
Part #600.10
Qty. 1
Upper Rear Door Rail Left
Part #600.11
Qty. 1
P29 - 56873 Rev. J 1121
Step 1
Mount the Upper Rear Door Rail (Part #600.10 Right
Side) and (Part #600.11 Left Side) to the vehicle using
two (2) of the M8 X 1.25 X 28 screws. (Part #534.24)
Leave fasteners loose at this time.
Installation Instructions - Trektop for Bronco 4 Door
Step 2
Fold the whole Top (Deck Assembly) back.
(Including the #1 bow) to gain access to the front screw
locations.
Install two (2) of the M6 X 1.0X 15.0 Screws
(Part #533.61) through the Upper Rear Door Rail into the
main bow mount. Make sure the Rear Door Rail doesn't
overlap the Front Door Rail. Now you can tighten the
fasteners that hold both the front and rear Door Rails
secure.
Repeat this step on the left side of the vehicle.
Page 29
© 2021 Bestop, Inc.