Dibo JMB-MG Mode D'emploi page 129

1 high pressure function
2 low pressure function / high
temperature function
HARDNESS (IN °F)
15
20
25
30
35
40
45
Depending on the scale deposits the pump may be put to the middle position (1
liter = 3h 55 mins.). Adjust the other settings experimentally according the local
hardness / application / cleaning temperature.
Attention: always set the softener pump
to position: ON, do not turn off!
The burner can still work approx. 2 hours before the PLC switches off the burner.
During these 2 hours, a message will appear on the display to indicate that the
softening product tank is empty. The softener pump will not work at using cold
water but jumps automatically on when the gas block is activated and the pump
will work during xx sec. when the gas block is deactivated! The softener pump
has also a run dry protection of the softening tank.
Consult, if necessary, the delivered safety data sheet (1.837.900) of
the softener product. Check the measures on exposure controls/
personal protection / first aid measures / firefighting measures.
22 O P T I O N H I G H T E M P E R AT U R E F U N C T I O N
Use the special spray lance when you work at high temperatures (see picture)!
Make sure that the valve is set to 'high temperature function' when you work
with high temperatures! Mount the lances on the screw coupling and snap into
the holder (see picture left).
High temperature
The 'high temperature control' function is a function that allows to control
pollution (weed) using a hot water principle. The valve is located to the frame.
• Valve vertical: high pressure washing activated (see symbol underneath - use
the appropriate lance).
• Valve horizontal: 'high temperature' function activated (low pressure) (see
symbol underneath, use the appropriate lance).
-
Please pay attention for the hot surface of the swivel connection
from the reel at operating the valve. Do not touch!
1
2
DiBO 23
HARDNESS (IN °D)
8.4
11.2
14
16.8
19.6
22.4
25.2
2
E N
O P E R AT I O N
POSITION PUMP
1
2
3
4
5
6
7
2