Transmitter/Receiver Learn Routine - GM VSL 4000 Guide D'installation

transmitter/receiver learn routine

The system comes with two transmitters that have been taught to the receiver. The receiver can store up to four
different transmitter codes in memory. Use the following learn routine to add transmitters to the system or to
change button assignments if desired.
When the learn routine has previously been programmed using an optional hand-held system programmer
(GM P/N 9M904965), it may have been locked. Before proceeding with reprogramming the learn routine,
it must be unlocked by using an optional hand-held system programmer - this cannot be done manually with the
Valet switch. If the learn routine is locked, transmitters cannot be programmed to the system.
1. Open a door. (The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)
2. Turn the ignition on. (The YELLOW wire, H1/9 must be connected.)
3. Select the receiver channel. Press and release the Valet/program switch the number of
times necessary to access the desired channel. Press and HOLD the Valet/program switch
once more. The siren will chirp and the LED will blink the number of times corresponding
to the channel that has been accessed.
CHANNEL PRESS AND RELEASE
NUMBER THE VALET/PROGRAM SWITCH
1* One time
2** Two times
3 Three times
4 Four times
5 Five times
6 Six times
7*** Seven times
8*** Eight times
9*** Nine times
*CHANNEL 1 AUTO-LEARN: Programming transmitter button one to channel one will automatically configure the
channels in the standard configuration. (Refer to the Transmitter Configuration section of this guide.)
NVSL4000
All manuals and user guides at all-guides.com
TO PROGRAM FUNCTION
Auto-Learn Standard Configuration
Delete all transmitters
Arm/Disarm/Panic
Channel Two
Channel Three
Channel Four
Arm
Disarm
Panic
27 - English
WIRE
COLOR
Red/White
White/Blue
Violet/Black