GM 19132699 Instructions De Montage

Splash Guard Rear
Please read instructions thoroughly before starting.
Installation time: 30 minutes
Package Contents:
Description
Left Hand Splash Guard
Right Hand Splash Guard
#10 x 3/4" Screw
#14 x 3/4" Screw
#14 Spring Clip
Instruction Sheet
Tools Required:
#2 Phillips Screwdriver
3/32" (2.5mm) Drill Bit
Hammer
Installation Procedure
1. Clean and degrease body panel where splash guards are to
be located.
2. Identify panel edge bolt, location A, and push pin location C,
Remove bolt and push pin, do not discard. See figure 1.
3. Pull liner forward and install supplied spring clip over hole C.
See figure 1 and 2.
4. Position splash guard so liner passes through slot and lock
tab is clipped over bumper panel edge. See figures 1 and
3.
5. While holding splash guard firmly against panel, install
existing bolt, location A and supplied screw location C. See
figure 1.
6. While holding splash guard firmly against panel, mark and
drill center pilot hole in location B. See figure 1.
7. While holding splash guard firmly against panel, install
supplied screw in location B. Do not overtighten.
8. Repeat procedure for other side.
9. Guards can be cleaned with any commercially available
cleaner.
Splash Guard - Rear
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 21NO05 I
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
1
1
2
2
2
1
Center Punch
Drill
Clean Cloth/Rag
REVISION AUTH
FIGURE 1
EXISTING
BOLT
SUPPLIED
#10 SCREW
SUPPLIED
#14 SCREW
FIGURE 2
SUPPLIED #14
SPRING CLIP
LINER
NOTE: INSTALL SUPPLIED SPRING CLIPS WITH TURNED
UP EDGE ON INSIDE OF PANEL EDGE.
FIGURE 3
SPLASH GUARD
IR 21NO05
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Splash Guard Rear
PART NO.
19132699
6200 Grand Pointe Dr., Grand Blanc, MI 48439
SUPPLIED
#14 SPRING CLIP
SPLASH GUARD
PANEL
SPLASH
PANEL
19132699
SHEET
1
SHEET
GUARD
SUPPLIED
#14 SCREW
LOCK TAB
1
3
OF
3
OF