GM VSL 4000 Guide D'installation page 30

4. Program the feature: While HOLDING the Valet/program switch, you can toggle the
feature on and off using the remote transmitter. Pressing the button that arms the system
will select the one-chirp (default) setting. Pressing the disarm button (or the channel 2
button on a remote with single-button arm/disarm), will select the two-chirp setting.
NOTE: The Valet pulse count feature (8) and the Channel 3 output (9) have five possible settings
each. Pressing the disarm button (or the channel 2 button on a remote with single-button
arm/disarm) will toggle through all the possible settings.
5. Release the Valet/program switch.
Once the feature is programmed:
I Other features can be programmed.
I The Learn Routine can be exited if programming is complete.
To access another feature:
After you have programmed a feature in Step 4 of the learn routine, press and release the Valet/program switch
the number of times necessary to advance from the feature you just programmed to the next one you want to
program. Then press the Valet/program switch once more and HOLD it. For example, if you just programmed the
third feature and you would like to program the seventh feature in the menu, you would: Press and release the
Valet/program switch four times. Then press it once more and HOLD it. The siren would chirp seven times to
confirm access to the seventh feature.
To exit the learn routine, do one of the following:
I Close the open door.
I Turn the ignition on.
I No activity for longer than 15 seconds.
I Press the Valet/program switch too many times.
All manuals and user guides at all-guides.com
30 - English
NVSL4000