Table Of Zones; Long-Term Event History - GM VSL 4000 Guide D'installation

9 CHANNEL 3 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SECOND TIMED/SECOND UNLOCK
OUTPUT: Channel 3 can be programmed for these output configurations. The unit is set to the default validity
output. To change the configuration, use the disarm (or channel 2) button to toggle to the different

table of zones

When using the diagnostic functions, use the Table of Zones to determine which input has triggered the system.
It is also helpful in deciding which input to use when connecting optional sensors and switches.
ZONE NO. TRIGGER TYPE
1 Instant
2 Multiplexed
3 Two-stage, progresses from
warning to full alarm
4 Multiplex
5 Two-stage, progresses from
warning to full alarm
NOTE: The Warn Away response does not report on the LED.

long-term event history

The system stores the last two full triggers in memory. (The Warn Away triggers are not stored to memory.) These
are not erasable. Each time the unit senses a full trigger, the older of the two triggers in memory will be replaced
by the new trigger. To access long-term event history:
1. Turn on the ignition.
2. Press and hold the Valet/program switch. The LED will flash in groups indicating the last
two zones that triggered the unit.
All manuals and user guides at all-guides.com
INPUT DESCRIPTION
H1/6 BLUE wire. Connects to optional hood/trunk pins.
Heavy impact detected by the on-board shock sensor.
Door switch circuit. H1/5 GREEN or H1/7 VIOLET.
BLUE and GREEN wires of optional sensor plug. Inputs
longer than 0.8 seconds will instantly trigger the full
alarm sequence and report zone 4.
Ignition. H1/9 YELLOW.
32 - English
settings.
NVSL4000