Matching The Controller To The Transmitter - GM Profi V80R Notice D'instructions

Connection to receiver
The speedos are fitted with a JR radio plug.
If you use a different radio system you may
have to change the order of the wires
to coincide with your radio equipment.
red = receiver positive
brown = receiver negative
orange = receiver impulse
ON/OFF-Switch:
Switching ON:
1. Switch on your radio
2. Connect the speed controller to the battery
3. Switch on the speed controller
Switching OFF:
1. Switch off the speed controller
2. Unconnect the battery
3. Switch off the radio
Radio Adjustment
Connect motor and battery to your speedo as described earlier in this manual.
Turn on your transmitter and set all throttle rates to 100%.
Turn on your speedo at the switch.
Press the set button once. The LED is on. Do not move the throttle on your
transmitter. After about 2 seconds the LED turns off (neutral saved). During the
next 3 secs give full throttle, full brake and then back to neutral on your
transmitter. If you press now the SET-button until the 3 short LED signals
occur, all additional functions are reset to factory settings.
The speedo is now tuned to your transmitter.
To check you have tuned it properly, the LED will light at neutral, full speed
and full brake.
If it does not, repeat the above section.
Factory settings:
BRKMIN=0%, BRKMAX=100%, AUTOBRK=0%, REVERSE=100%, time to
reverse=98, Powercurve=linear, reverse at motor stop activated
Change order of wires
1
3
2
14