Stihl MS 362 C-Q Notice D'emploi page 8

English
Do not touch the chain while the engine
is running. If the chain becomes jammed
by an obstruction, switch off the engine
immediately before attempting to
remove the obstruction.
To reduce the risk of injury, shut off
the engine before changing the saw
chain.
To reduce the risk of fire, do not
smoke while operating or standing near
your power tool. Note that combustible
fuel vapor may escape from the fuel
system.
If your power tool is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work – see also
"Before Starting". Check the fuel system
in particular for leaks and make sure the
safety devices are working properly. Do
not continue operating your power tool if
it is damaged. In case of doubt, have the
machine checked by your servicing
dealer.
Make sure the idle speed setting is
correct. The chain must not run when
the engine is idling with the throttle
trigger released. Check and correct the
idle speed setting at regular intervals. If
the saw chain still moves, have your
dealer check your machine and make
proper adjustments or repairs.
Reactive Forces
The most common reactive forces that
occur during cutting are: kickback,
pushback and pull-in.
6
All manuals and user guides at all-guides.com
Dangers of kickback
Kickback can result in
serious or fatal injury.
Kickback occurs when the saw is
suddenly thrown up and back in an
uncontrolled arc towards the operator.
Kickback occurs, e.g.
– when the upper quadrant of the bar
nose unintentionally contacts wood
or another solid object, e.g. when
another limb is touched accidentally
during limbing.
– when the chain at the nose of the
guide bar is pinched in the cut.
Quickstop chain brake:
This device reduces the risk of injury in
certain situations – it cannot prevent
kickback. If activated, the brake stops
the saw chain within a fraction of a
second – for a description of this device
refer to chapter on "Chain Brake" in this
manual.
To reduce the risk of kickback
– Work cautiously and avoid
situations which could cause
kickback.
– Hold the saw firmly with both hands
and maintain a secure grip.
– Always cut at full throttle.
– Be aware of the location of the guide
bar nose at all times.
– Do not cut with the bar nose.
– Take special care with small, tough
limbs, they may catch the chain.
MS 362 C-Q