Taking Care Of The Guide Bar; Air Filter System - Stihl MS 362 C-Q Notice D'emploi

English
Taking Care of the Guide
Bar
2
1
N Turn the bar over – every time you
sharpen the chain and every time
you replace the chain – this helps
avoid one-sided wear, especially at
the nose and underside of the bar.
N Regularly clean the oil inlet hole (1),
the oilway (2) and the bar
groove (3).
N
Measure the groove depth – with
the scale on the filing gauge (special
accessory) – in the area used most
for cutting.
Chain type Pitch Minimum
groove depth
Picco 3/8" P 5.0 mm
Rapid 1/4" 4.0 mm
Rapid 3/8"; 0.325" 6.0 mm
Rapid 0.404" 7.0 mm
28
All manuals and user guides at all-guides.com
If groove depth is less than specified:
N
Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
3

Air Filter System

The air filter system can be adapted to
suit different operating conditions by
installing a choice of filters. Changing
the filter is quick and simple.
The saw comes standard with either a
fleece filter or a fabric filter.
Fleece filter with felt prefilter
For normal, dry and very dusty work
areas.
Fabric filter
For severe winter conditions (e.g.
powder and drifting snow, frost).
MS 362 C-Q