Renkforce 1312695 Notice D'emploi page 96

All manuals and user guides at all-guides.com
b) General
The setup menu of the mobile unit can only be reached when the mobile unit is in standby mode. This is not
possible during a call and the key lock must not be active.
• From the standby mode, the setup menu is called by briefly pushing the left function button (1).
• Use the buttons „ " (2) or „
• Depending on the function just selected, the left (1) or right function button (9) is used to operate or make
settings or leave a function or cancel. Observe the corresponding display texts above the respective
function button.
• When a setting is changed and saved, the mobile unit emits a sound.
• Use the button „ " (10) to leave the setup menu at once.
The setup menu is also left automatically if you do not push any button for 40 seconds.
Any changes made are not saved in either case.
c) Caller List
As described in chapter 11. k), the caller list contains the numbers of missed or rejected calls. This is only
possible if the numbers have been submitted via the phone grid, of course.
In addition to the direct display of the caller list with the button „
played and processed in the setup menu of the mobile unit.
• Starting in the standby mode, briefly push left function button (1).
• Use the buttons „ " (2) or „
again.
The further description to assume a call number from the caller list into the phone book of the
mobile unit, deleting of an individual number or deleting the entire caller list is found in chapter
11. k).
96
" (12) to select the desired function.
" (12) to select the caller list and push the left function button (1)
" (2), the caller list can also be dis-