Renkforce 1312695 Notice D'emploi page 110

All manuals and user guides at all-guides.com
u Reset Mobile Unit
• Starting in the standby mode, briefly push left function button (1).
• Use the buttons „
(„HS Settings") and push the left function button (1) briefly for confirmation.
• Use the buttons „ " (2) or „
button (1) briefly for confirmation.
• Then enter the PIN with the numeric buttons (in the delivery condition „0000"). Push the left function
button (1) briefly for confirmation.
• If the PIN has been entered correctly, the mobile unit is reset to factory settings.
u Log on the Mobile Unit at the Basis Station
The enclosed mobile unit is already logged on to the basis station and ready for operation. You can log on
up to 5 mobile units to the basis station.
The basis station supports the DECT/GAP standard.
However, it must be observed that the function of the door opener (push button „#" (13) for
3 seconds) expands this standard.
This means that a „normal" DECT/GAP mobile unit does not provide the door opener function.
However, a special mobile unit with the door opener function is available as an accessory
(Conrad item no. 551474).
• Take the mobile unit you want to log on into operation (insert rechargeable batteries and charge if requi-
red). The basis station also must be connected to the operating power, of course.
• Keep the pager button (19) at the bottom of the basis station pushed for at least 5 seconds and then
release the button again.
• Starting in the standby mode, briefly push left function button (1) at the mobile unit.
• Use the buttons „
(„HS Settings") and push the left function button (1) briefly for confirmation.
• Use the buttons „ " (2) or „
left function button (1) briefly for confirmation.
• Then a list with basis station numbers appears. Use the buttons „
which you want to assign the number to the mobile unit.
• If the basis station has been found, the PIN of the basis station must be entered (in the default condition,
this is „0000").
110
" (2) or „ " (12) to select the submenu for the setting of the mobile unit
" (12) to select the submenu for the resetting and push the left function
" (2) or „ " (12) to select the submenu for the setting of the mobile unit
" (12) to select the submenu for logging on the mobile unit and push the
" (2) and „ " (12) to select one for