Renkforce 1312695 Notice D'emploi page 92

All manuals and user guides at all-guides.com
k) Caller List
If the caller submits a phone number (and your phone grid or phone system permits this) the number is
displayed on the mobile unit.
If you have missed or not accepted one or several calls, the display will show the symbol „
storage for the caller list in the mobile unit is full, the symbol flashes.
Depending on the phone grid and the settings in the caller's end device, the mobile unit will show the cor-
responding message for a missing number, e.g. that the number is unknown (number is not submitted) or
private (number has been suppressed by the caller).
Note:
The mobile unit must be in standby mode for the following operating steps. It must not be swit-
ched off or in a menu, etc.
u Show Caller List
• Briefly push the button „
Alternatively, you can call the menu of the mobile unit. For this, push the left function button (1).
Then use the buttons „
button (1) again.
• If you have any missed calls, the first number appears now.
• If there is more than one missed call, you can display them in sequence with the buttons „
„ " (12). At the end of the displayed list, the mobile unit emits a sound signal.
• Push the button „ " (10) to leave the display. The mobile unit is in standby mode again.
u Add Number from the Caller List to the Phone Book
This function permits assuming a number from the caller list into the phone book subsequently.
Proceed as follows:
• Briefly push the button „
• If there is more than one missed call, you can display then in sequence with the buttons „
„ " (12).
• Push the left function button (1) to call the associated submenu.
• Use the buttons „ " (2) or „
selection with the left function button (1).
• Then the mobile unit asks about the name of the participant. Enter it with the numeric keyboard.
92
" (2).
" (2) or „ " (12) to select the caller list and push the left function
" (2). If you have any missed calls, the first number appears now.
" (12) to select the corresponding function for adding and confirm the
". If the
" (2) or
" (2) or