Stopping Heating / Frost Protection; Taking The Appliance Out Of Use; Operation Ckt 20 S; Starting Heating - Stiebel Eltron CK 20 S Utilisation Et Installation

OPERATION

OPERATION CKT 20 S

6.2 Control with external room temperature con-
troller
2
In rooms larger than 20 m you can operate the appliance with a
conventional external room temperature controller.
f To do so, turn the temperature selector fully clockwise.
6.3

Stopping heating / Frost protection

f Turn the temperature selector fully anti-clockwise and select
quick heating stage "II" on the rocker switch.
This position ensures frost protection. The heater starts automati-
cally if the room temperature drops below the frost protection
temperature.
6.4

Taking the appliance out of use

f Pull the plug from the power socket.
7. Operation CKT 20 S
1
2
1 Temperature selector
2 Time switch
7.1

Starting heating

The temperature is infinitely adjustable. The appliance switches
off as soon as the selected room temperature has been reached.
f Turn the temperature selector clockwise to the required
setting.
7.2

Adjusting the time switch

With the time switch, the appliance heats with full output and
without temperature control.
f Turn the time switch selector clockwise to set any number of
minutes to count down, from 0 - 60 minutes.
7.3 Stopping heating / Frost protection
f Turn the temperature selector fully anti-clockwise and ensure
that the time switch is set to "0".
This position ensures frost protection. The heater starts automati-
cally if the room temperature drops below the frost protection
temperature.
7.4 Taking the appliance out of use
f Pull the plug from the power socket.
WWW.STIEBEL-ELTRON.COM
8.

Cleaning, care and maintenance

The appliance contains no user serviceable parts.
Clean the appliance when cold with ordinary cleaning products.
Avoid abrasive or corrosive cleaning products.
If a pale brownish discolouration appears on the appliance casing,
wipe this off as soon as possible with a damp cloth.
Damage to the appliance and environment
!
Never spray cleaning spray into the air slot.
9.

Storage

f When not in use, keep the appliance in a dry place.

10. Troubleshooting

If the appliance does not heat, check the temperature set at the
appliance and the MCB/fuse in your fuse box.
The appliance has a temperature limiter that shuts the appliance
down if it overheats. After the cause has been removed (for ex-
ample air outlet or inlet apertures covered) and the appliance has
cooled down for a few minutes, operation starts again.
If you cannot remedy the fault, notify your heating contractor. To
facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-000000).
CK 20, CKZ 20, CKR 20, CKT 20 | 19