Checking Chain Lubrication - Stihl MSA 200 C Notice D'emploi

Filler cap is locked
If the filler cap will not lock onto the oil
tank
The base of the filler cap is tilted in
relation to the upper part.
Remove the filler cap from the oil
N
tank and look at it from above
1
Left: Base of filler cap is tilted –
interior marking (1) is aligned
with the exterior marking
Right: Base of filler cap is in the cor -
rect position – interior
marking is below the clip. It
does not align with the exte -
rior marking
MSA 200 C
All manuals and user guides at all-guides.com
Fit filler cap and twist it
N
counterclockwise until it engages in
the seat of the filling port
Continue to twist the filler cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position
Twist the filler cap clockwise and
N
close it – see section "Closing"

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
English
69