Tensioning The Saw Chain (Quick Chain Tensioner) - Stihl MSA 200 C Notice D'emploi

English
Fit the saw chain – starting at the
N
nose of the guide bar – pay attention
to the position of the tensioning gear
and the cutting edges
Turn tensioning gear (1) to the right
N
as far as possible
Turn the guide bar so that the
N
tensioning gear faces the user
3
2
Place the saw chain on the chain
N
sprocket (2)
Slide the guide bar over the collar
N
screw (3); the head of the rear collar
screw must protrude into the oblong
hole
Guide the drive link into the bar
N
groove (arrow) and turn the
tensioning gear to the left as far as
possible
66
All manuals and user guides at all-guides.com
Fit chain sprocket cover, sliding the
N
guide lugs into the engine housing
openings
5
When fitting the chain sprocket cover,
the teeth of the adjusting wheel and the
tensioning gear must mesh; if
necessary,
turn the adjusting wheel (4) a little
N
until the chain sprocket cover can
be slid completely against the
engine housing
Swing grip (5) into position (until it
N
engages)
Fit wing nut and tighten lightly
N
Go to chapter "Tensioning the saw
N
chain"
Tensioning the Saw Chain
(quick chain tensioner)
For retensioning during operation:
Remove the battery from the
N
4
machine
Fold out the wings of the wing nut
N
and loosen the wing nut
Turn the adjusting wheel (1) to the
N
right as far as possible
Tighten the wing nut (2) by hand
N
Fold in the wings of the wing nut
N
Next step: Continue with "Check
N
chain tension"
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period!
Check chain tension frequently –
N
see "Operating Instructions"
1
2
MSA 200 C