Checking Chain Lubrication; Chain Brake - Stihl MS 201 C-M Notice D'emploi

English
If the oil level in the tank does not go
down, the reason may be a problem in
the oil supply system: Check chain
lubrication, clean the oilways, contact
your dealer for assistance if necessary.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
24

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".

Chain Brake

Locking the Chain
in an emergency
–
when starting
–
at idling speed
–
The chain brake is activated by pushing
the hand guard towards the bar nose
with your left hand – or by inertia in
certain kickback situations:
Disengaging the Chain Brake
Pull the hand guard back towards
N
the front handle.
MS 201 C-M