The Remote Control; Other Problems - Samsung DVD-VR350 Manuel D'instructions

Troubleshooting (DVD)
Problem
You cannot use the operation or function due to one of the following reasons:
icon appears on
(1) Your DVD disc does not support the feature (for example, angles)
the screen.
(2) You've requested a title, chapter, or scan time that is out of the correct range.
Play mode settings
are different from the The disc does not support all the selected functions.
settings confi gured In this case, some settings you confi gure on the Setting menu may not work properly.
with the Setting menu.
Cannot change the
Aspect ratio is fi xed for DVD disc.
aspect ratio.
Check whether you selected correct digital output options in the Audio Output Options
No audio output.
menu.
Did you move your DVD Recorder & VCR suddenly from a cold place to a warm place?
No video or audio output.
In this case, do not connect the plug to the power outlet and wait for two hours.
The disc tray is ejected
Then insert the disc and try to play again.It will work properly when condensation has
after 2 to 5 seconds.
evaporated.
Angle operation
Angle operation is available only when the disc contains images captured at different
does not work during
angles.
playback of a DVD disc.
• Check whether there is damage or foreign materials on your disc.
The disc revolves, but
• Some discs with bad manufacturing quality may not be played back.
no image or bad quality
• If the scene changes from dark to bright suddenly, the screen may jitter temporarily, but
images are output.
Desired audio
Audio languages and subtitle languages are disc-specifi c.
language and subtitle
Only the sound and subtitle languages contained on a DVD disc are available and
language are not
displayed on the disc menu.
played.
• Check whether PS
No progressive
• Make sure to change the component video output using the Progressive button when
output.
• Point the remote control at the remote control sensor on your DVD Recorder & VCR.

The remote control

doesn't work.
• Check whether the batteries are depleted.
• Read the table of contents and then fi nd and read the sections describing your

Other problems

• Turn the unit off and on.
• If your problem still persists, contact your nearest Samsung service centre.
• Check the Video output is HDMI enabled.
No HDMI output.
• Check the connection between the TV and the HDMI jack of the DVD Recorder & VCR.
(DVD-VR355 only)
• See if your TV supports this 576p/720p/1080i DVD Recorder & VCR.
Abnormal HDMI
• If snow noise appears on the screen, it means that TV does not support HDCP
output screen.
(DVD-VR355 only)
• Check your TV system setup correctly.
HDMI output Jitter • Screen Jitter may occur when the frame rate is converted from 50Hz to 60Hz for
(DVD-VR355 only)
• Please refer to the user's manual of your TV.
Explanation/Solution
it is not a defect.
is displayed on front panel.
the disc is stopped.
Operate within distance. (15ft)
Remove obstacles between your DVD Recorder & VCR and remote control.
problem, and follow the directions given.
(High-bandwidth Digital Content Protection).
720p/1080i HDMI (High Defi nition Multimedia Interface) Output.
English - 81