Setting Up The Audio Options; Digital Output - Samsung DVD-VR350 Manuel D'instructions

DVD-Recorder
Audio
No Disc
Programme

Digital Output

: PCM
DTS : Off
Setup
Dynamic Compression : On
NICAM : On
MOVE OK RETURN EXIT
DVD-Recorder Audio
No Disc
Programme
Digital Output : PCM
DTS : Off
Setup
Dynamic Compression : On
NICAM : On
MOVE OK RETURN EXIT
DVD-Recorder
Audio
No Disc
Programme
Digital Output : PCM
DTS : Off
Setup
Dynamic Compression : On
NICAM : On
MOVE OK RETURN EXIT
DVD-Recorder Audio
No Disc
Programme
Digital Output : PCM
DTS : Off
Setup
Dynamic Compression : On
NICAM : On
MOVE OK RETURN EXIT

Setting Up the Audio Options

Allows you to setup the audio device and sound status settings
depending on the audio system in use.
You can also adjust the NICAM mode.
1. With the unit in Stop mode/No Disc mode, press the MENU button.
2. Press the ▲▼ buttons to select Setup, then press the OK or ► button.
3. Press the ▲▼ buttons to select Audio, then press the OK or ► button.
Audio setup menu will be displayed.
4. Press the ▲▼ buttons to select the desired audio option, then press
the OK or ► button.
5. Press the ▲▼ buttons to select the desired item, then press the OK or
► button.
▌ Digital Output
• PCM : Converts to PCM (2CH) 48kHz audio. Select PCM when using
►
► the Analog Audio Outputs.
►
• Bitstream : Converts to Dolby Digital Bitstream. Select Bitstream when
►
using the Digital Audio Output.
■ Be sure to select the correct Digital Output or no audio will be heard.
▌ DTS
• Off : Doesn't output digital signal.
►
►
• On : Outputs DTS Bitstream via digital output only. Select DTS when
►
► connecting to a DTS Decoder.
■ When DTS soundtrack is played, sound is not output from Analog
Audio Output.
▌ Dynamic Compression
This is only active when a Dolby Digital signal is detected.
►
►
• On : When Movie soundtracks are played at low volume or from smaller
►
►
speakers, the system can apply appropriate compression to make
low-level content more intelligible and prevent dramatic passages
from getting too loud.
• Off : You can enjoy the movie with the standard Dynamic Range.
▌ NICAM
NICAM programmes are divided into 3 types.
►
►
NICAM Stereo, NICAM Mono and Bilingual (transmission in another
►
language).
►
NICAM programmes are always accompanied by astandard mono
sound broadcast and you can select the desired sound.
• On : NICAM mode
• Off : Only set at this position to record the standard mono sound during
a NICAM broadcast if the stereo sound is distorted due to inferior
reception conditions.
English - 27