Device Elements; Technical Data; Intended Use - Würth 0510 955 710 Traduction Des Instructions De Service D'origine

Device elements

1 Rocker switch
2
Mode button
3
Display
4
Start/Stop button
5
- Button
6
Select button
7
+ button

Technical data

Art.
Mains voltage
Rated current
E ciency
Input fuse
Rated voltage
Voltage range
Nominal current
Output fuse
Battery type
Battery rated capacity
Number of cells per battery
Reverse current
9-stage charging characteristic
Operating temperature
Storage temperature
Degree of protection
Protection class
Weight (including plug)
Dimensions (WxHxD) in mm

Intended use

This device is only to be used as an onboard supplier and rapid
charger for all common 12 V starter batteries.
Any other use is considered improper.
The user is responsible for damage resulting from
improper use.
18
All manuals and user guides at all-guides.com
0510 955 710
220-240VAC
~ 50/60Hz
1600W
93 %
Slow-blow 10A
12 VDC
2 – 16V
100 A
125 A
Wet lead-acid battery, lead-calcium(-sil-
ver), EFB, EFB+, GEL, AGM
20 - 1200 Ah
6
< 1 mA
IU I U
0 0
0°C - +40°C
-20°C - +80°C
IP21
I
5.8 kg
295 x 117 x 345
Description
The device has 5 modes, of which two are hidden.
— [Charging] mode: to charge starter batteries with an
Ladung
acid or gel electrolyte (lead, lead-calcium, lead-calcium- silver,
AGM, etc.) at 20 to 1200 Ah and 12 V.
— modes: the 100 A battery charger supports and sup-
Diag +
plies the onboard battery during diagnostics of all electric
consumers up to 100 A (engine cooling, window-lift motors,
onboard electronics, etc.) when the engine is stationary. In this
mode, the voltage at the battery can be set according to the
specification of the respective manufacturer.
— mode: supplies the battery with power during
Showroom
presentation of a demonstration car with all consumers (win-
dow-lift motor, heating, exterior mirrors, etc.). In this mode, the
voltage at the battery can be set according to the specification
of the respective manufacturer.
— [Battery change] mode: ensures a steady
Batterie tauschen
onboard voltage during removal of the battery to prevent loss
of stored information. In the standard setting, this mode is not
activated and does not appear in the list of modes.
— mode: Suitable for experienced users. It is not
Power Supply
activated in the standard setting and does not appear in the list
of modes. This mode enables the use of the charger as a pow-
erful DC voltage source, the voltage and supplied maximum
current of which can be adjusted. Mode for experienced users.
The devices have an automatic restart function, so that, in the event
of a power failure, for example
mode can be restarted. The function
Power Supply
limits the adjustment options to a minimum, to prevent incorrect oper-
ation of display vehicles.
Connect the device to the mains voltage.
f
Switch the on/o button [1] to
f
appears for three seconds on the display.
WÜRTH 100 A
3
Set the desired mode. If the mode is not selected, the device
f
accesses the last used settings (except
Press the button to access the following menu:
Mode
f
Ladung [Charging] > Diag+ > Showroom (>Battery
MODE
change*)
(> Power Supply*) *'hidden' in the standard setting.
To reach the settings, maintain the button pressed for three
f
seconds:
3 sec - Settings
MODE
[Charging],
Ladung Showroom
Lock Showroom
Start-up
.
ON
.
Diag +
or