Würth 0510 955 710 Traduction Des Instructions De Service D'origine page 20

DIAG+ modes
During diagnostics with the engine switched o , the device maintains
the power supply of the onboard battery for electrical consumers
(engine cooling, window-lift motors, onboard electronics, etc.) up to
100 A. It maintains a constant voltage from - 12 V to 14.8 V
Voltage adjustment:
The voltage at the battery can be adjusted in 0.1 V steps according
to the specification of the manufacturer in question.
Settings DIAG+ mode
DIAG+
U=13.5V
DIAG+
U=13.2V
Connect the charging clamps: red (+) and black (-) to the battery.
f
Press the START/STOP button.
f
The instantaneous consumed current and the instantaneous
f
voltage are displayed.
Start DIAG+ mode
DIAG+ 12V
U=13.5V
If the current indicated is higher than 10A, then the
battery is discharged. The device starts charging
automatically. Check that all vehicle electrical consumers
are switched o . Wait until the current is below 10 A,
before you carry out the diagnostics.
20
All manuals and user guides at all-guides.com
12V
12.0V
12V
12.1V
...
14.8V
DIAG+ 12V
U=13.5V
I=12A
CAUTION!
SHOWROOM mode
With the engine o , the device enables the use of electrical consum-
ers (engine cooling, window-lift motors, onboard electronics, etc.)
with a constant current of up to 100 A at an adjustable voltage from
12 V to 14.8 V
Voltage adjustment range:
It is possible to adjust voltage at the battery in 0.1 V steps according
to the specification of the manufacturer in question.
Settings SHOWROOM mode
SHOWROOM
U=13.5V
SHOWROOM
U=13.7V
First steps
Connect the charging clamps: red (+) and black (-) to the battery.
f
Press the START/STOP button.
f
The current consumption and the instantaneous voltage are
f
displayed.
Start SHOWROOM mode
SHOWROOM 12V
U=13.5V
Connection without battery (not recommended):
It is possible to supply the vehicle with current without the battery
f
being connected, by pressing the START/STOP button for three
seconds.
appears on the display before the vehicle is
No battery
3
supplied.
12V
12.0V
12V
12.1V
...
14.8V
SHOWROOM 12V
U=13.5V I=12A