Obtaining Technical Assistance - Bull NovaScale R440 F2 Mode D'emploi

3 Select the unpartitioned space again, and then press <c> to create a primary
hard-disk partition.
NOTE:
The partition will now be enumerated as C: drive.
4 Follow the on-screen instructions to create a partition. Windows will now
install on the C: drive.
For more information on assigning the Windows-bootable system partition to
the C: drive, see http://support.microsoft.com/kb/896536.
Other Information You May Need
WARNING:
system. Warranty information may be included within this document or as
a separate document.
• The rack documentation included with your rack solution describes how to
install your system into a rack.
• The Hardware Owner's Manual provides information about system features
and describes how to troubleshoot the system and install or replace system
components. This document is available online at
http://support.bull.com/documentation.
• Any media that ships with your system that provides documentation and
tools for configuring and managing your system, system management
software, system updates, and system components that you purchased with
your system.
NOTE:
updates first because they often supersede information in other documents.

Obtaining Technical Assistance

If you do not understand a procedure in this guide or if the system does not
perform as expected, see
documentation, or contact your support representative; the phone directory is at
http://support.bull.com.
See the safety and regulatory information that shipped with your
Always check for updates on
http://support.bull.com/documentation
http://support.bull.com
Getting Started With Your System
and read the
for further
11