Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
English
TROUBLESHOOTING
Symptom
Tool will not start when
operating the on/off switch.
Cutting depth is less than that
is set.
Blade spins or slips
Blade will not cut a straight
line.
36
7062244_MaxxSaw_Ma_#1503-19.indb 36
All manuals and user guides at all-guides.com
Possible Causes
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn
down.
Sawdust accumulated,
blocking the base.
Blade is not tightly engaged
with the spindle.
Blade is dull.
Blade is not mounted
properly.
Saw is not being guided
properly.
Possible Solution
Check to make sure power
cord is connected well into a
working outlet.
Unplug the power cord.
Replace it by a qualified
maintenance person.
Replace the carbon brush by
a qualified maintenance
person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade, and
reassembled it as described
in install /change the Blade
section.
Mount a new, sharp blade on
the saw.
Check that blade is properly
mounted.
Use and edge guide.
09-04-15 11:31
Publicité
Table des Matières
