Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
English
and remove the cause for the saw-
blade's jamming.
c.
If you wish to restart a saw that is
already in the workpiece, centre the
saw blade in the cut and check that the
teeth are not snagged in the workpiece.
If the saw blade jams, it may run out of
the workpiece or cause a kickback when
the saw is restarted.
d. Provide support for large sheets to
reduce the risk of a kickback through
jamming of the saw blade. Large
sheets can bend under their own
weight. The sheets must be supported
on both sides, at the edges and close to
the saw cut.
e.
Do not use blunt or damaged saw
blades. If saw blades with blunt or mis-
aligned teeth are used, the saw cut is too
narrow resulting in increased friction,
jamming of the blade and kickback.
f.
Before sawing, firmly tighten the
adjustments of the cutting depth and
cutting angle. If the settings adjust
themselves during sawing, the saw blade
may become clamped and a kickback
will occur.
g.
Be especially careful, if you are making
a plunge cut in an existing wall or other
nonvisible area. The immersed saw
blade can jam when sawing into hidden
objects and cause a kickback.
SAFETY INSTRUCTIONS FOR THIS
COMPACT PLUNGE SAW
a.
Check before each use that the safety
guard closes correctly. Do not use the
saw if the lower safety guard does not
move freely and does not close imme-
diately. Never clamp or secure the
lower safety guard in the open position.
If the saw should accidentally fall to the
ground, the lower safety guard may
become bent. Open the safety guard
with the retraction lever and ensure that
it moves freely. Check that it does not
interfere with the saw blade or other
components, at any cutting angle or
cutting depth.
b.
Check the condition and operation of
the spring for the lower safety guard.
26
7062244_MaxxSaw_Ma_#1503-19.indb 26
All manuals and user guides at all-guides.com
c.
d. Do not put down the saw on the work-
e.
f.
SAFETY INSTRUCTIONS FOR CUT OFF
GRINDING APPLICATIONS
Safety instructions for cut off grinders
a.
b.
c.
Do not use the equipment if the lower
safety guard and spring do not work
perfectly. Damaged parts, adhesive
deposits or accumulations of shavings
retard the operation of the lower safety
guard.
When making a plunge cut which is not
at right angles, make sure that the
saw's guide plate can not move later-
ally. Lateral movements can cause the
saw blade to jam and hence result in
kickback.
bench or floor, without the lower safety
guard covering the saw blade. When
slowing down after use, an unprotected
saw blade will move the saw in the direc-
tion opposite to the cutting direction and
will saw whatever lies in its path. Pay
attention, therefore, to the deceleration
time of the saw.
Use only sawblades with the correct
diameter according to what is printed
on the saw.
When sawing plastics please ensure
not to overheat the saw teeth tips to
avoid melting the plastic.
The safety guard for the electric power
tool must be securely attached and
adjusted so that maximum safety is
attained, i.e. the smallest possible
portion of the grinding wheel shows
openly to the operator. Make sure that
you and any other nearby individuals
are not in the plane of the rotating
grinding disc. The safety guard is
intended to protect the operator from
fragments and from accidental contact
with the grinding wheel.
Use only diamond cutting discs for
your electric power tool. The fact that
you can attach an accessory to your
electric power tool, does not guarantee
that it is safe to use.
The permissible rotary speed of the
tool insert must be at least as high as
09-04-15 11:31
Publicité
Table des Matières
